Sandusky RTA-7001-07 Instruction Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 5
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Page 4
Step 4 - Top Assembly
A) Begin inserting the posts on the Top (I) into the
channels on the Right and Left Side Panels. Starting with
the Top on a slight angle may help.
B) Once both posts are started. Tap evenly down
on the Top (I) until it is just past the Side and
Back Panels. Make sure the Top (I) is going
OVER the Side and Back Panels.
C) Check under the Top (I) to make certain
that the Side and Back Panels are INSIDE
the supports.
D) Tap the Top (I) down around the edges until the
tabs on the Side and Back Panels snap into the square
holes on the supports .
Top - I
Posts
Insert the
Posts into
the channel
on each of
the Side
Panels
Tap the Top down
evenly until it is
just past the
Side and Back
Panels
Begin lowering the
Top by tapping just
over the Posts
Keep the Top as
level as possible
IMPORTANT:
The Top must be
OVER all the
Side and Back
Panels
IMPORTANT:
The Side and Back Panels
must be inside the supports
located under the Top
Side Support
Back Support
Tap down the Top
evenly until the Tabs
lock it in place
View under Top showing Side and Back Panel
supports and partial engagement
Back Tab
Side Tab
The Tabs on the Side and
Back Panels lock into the
square holes on the
Supports
Side Support
Back Support
Step 5 - Shelf Installation
A) At the desired shelf height, insert 2 Shelf
Clips (K) into the holes located inside
the front edges of the Side Panels.
B) Angle a Shelf (J) into the cabinet above
the installed Clips with its rear tilted down.
C) Insert the rear of the Shelf (J) into the slots
in the Back Panels that are closest in height
to the installed Shelf Clips.
D) Tilt the Shelf (J) down until it rests on the
Shelf Clips. If the Shelf is uneven,
reposition the Shelf Clips into appropriate
locations to level it.
E) Repeat this process for all of the shelves.
Shelf Clip - K
Insert the top of
the Clip and angle it
down
Snap the botton of
the Clip into the hole
Shelf -J
Insert the rear
of the Shelf
into the
slots
Tilt the front
of the Shelf
down and
rest it on
the Shelf
Clips
Reposition
the Shelf
Clips to level
the Shelf if
necessary
Shelf
Clip - K
Square Hole
View under Top showing Side and Back Panel
tabs fully engaged
Channel
Square Hole
Quick Assembly Storage Cabinets
Page view 3
1 2 3 4 5

Comments to this Manuals

No comments